The 24V Solar Panel with Mounting Kit provides maintenance charging for compatible battery-powered boat lift systems. It is designed for a two-battery 24V configuration and includes the panel plus mounting components used to position it high on the lift upright for useful sun exposure. Solar charging is especially helpful at waterfronts without convenient AC service, but battery condition, lift use, shade and seasonal sunlight all affect charging performance.
What the Solar Kit Adds
Off-Grid Maintenance Charging
Helps replenish normal battery use between lift cycles without running permanent AC power to the dock.
20-Watt Panel
The included panel is sized for a compatible 24V lift-battery maintenance charging application.
Winch-Post Mounting System
The mounting arm, cross-frame components and stainless gear clamps secure the panel to the lift upright.
Clean Wire Management
Included cable ties help route the panel leads away from sharp edges and moving parts.
What’s Included
- One 20-watt solar panel
- Mounting arm, cross frames, crossbar and center bracket
- Two stainless-steel gear clamps plus panel-mounting fasteners
- Cable ties and installation hardware
- Part Number 1026098
Not Included
- Two 12V marine batteries
- Battery boxes or trays
- Battery-to-battery jumper or quick-connect bridge unless already included elsewhere in your system
- Boat lift motor or lift
This Kit Is for 24V Systems Only
A 24V lift setup normally uses two compatible 12V batteries wired in series. Follow the polarity diagram exactly: an incorrect connection can damage equipment and create an arc-flash or shock hazard.
Need the battery connection between the two batteries? Compare the ShoreMaster 24V jumper wire and the Connect-Ease bridge connector for your approved setup.
Installation & Placement Tips
Mount for Sun Exposure
High on the Lift Upright
- Position the panel where it receives the most unobstructed daily sunlight.
- Keep the mount from rubbing against the canopy frame or cover.
- Tighten clamps and hardware securely, then recheck them periodically.
Protect the Wiring
Away from Moving Components
- Secure the cord with the included cable ties.
- Keep wires away from winch parts, cables, sharp edges and pinch points.
- Inspect the panel, leads and battery terminals throughout the season.
Complete the 24V Battery Setup
The solar panel maintains the battery system; it does not include the batteries. Use two compatible marine batteries in good condition and follow the motor and battery manufacturers’ charging guidance.
A shaded site, frequent lift use or weak batteries may require periodic supplemental charging even when a solar panel is installed.
Frequently Asked Questions
Can this panel charge a single 12V battery?
No. This listing is the 24V charging system and is intended for two 12V batteries wired in series. Use a compatible 12V charging product for a single-battery installation.
Does the kit include the batteries?
No. Batteries, battery trays and the inter-battery jumper are not included. Select marine batteries that meet the motor manufacturer’s requirements.
Will solar charging fully recharge dead batteries?
The panel is best used for maintenance charging between normal lift cycles. Charging speed depends on sunlight, battery capacity, battery condition and lift use. Severely discharged batteries may require an approved external charger.
Where does the solar panel mount?
The supplied arm and clamps are designed to attach high on the boat lift upright or winch post. Position it for sun exposure without allowing the mount or wiring to interfere with the canopy or moving lift components.
Can I use this with a 120V Lift Boss?
No. A 120V motor runs from AC power and does not use this 24V battery charging kit. This product is for a compatible battery-powered 24V lift system.
Need Help Completing a 24V Lift-Battery System?
Share your motor model and current battery setup. We can help identify the panel, jumper, battery tray and related components needed for a compatible installation.
Call 888-298-9702
